Please wait while the page loads...

What could cause the check engine light to come on in a Toyota 4Runner?

When your check engine light comes on, this could be as simple as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a serious problem that could cause serious damage to your engine and come with a hefty repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow typically means something less serious but a flashing check engine light indicates that your vehicle’s engine is in serious trouble and service is needed immediately. If your check engine light is flashing in your Toyota 4Runner, we highly recommend not to drive the vehicle and schedule Toyota service today. Below is a list of the most common reasons your check engine light can come on:

  • One of the most ongoing and several cause is that your Toyota 4Runner gas cap is loose, damaged or missing. The gas cap for your Toyota 4Runner serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on expeditiously after you put gas in your Toyota 4Runner, initial thing you should check is to make fearless the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your Toyota 4Runner has a vacuum leak. Every Toyota 4Runner has a vacuum system that performs a wide difference of functions. The vacuum system also helps reduce harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, notably if they’re exposed to extraordinary heat or extreme freezing.
  • So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your Toyota 4Runner's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to determine the polite mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Toyota 4Runner is what determines how much fuel is needed to run your engine efficiently by measuring the discharge of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to confident changes, same altitude. If your Toyota 4Runner is having trouble starting, idling rough or has a brisk change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, ordinary as the O2 sensor, measures the discharge of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be fewer convenient when it comes to fuel economy.
  • Issues with all aftermarket items. An aftermarket alarm, exhaust or alternative item can wreak havoc on your Toyota 4Runner if it’s not installed properly. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even impede the vehicle from starting. If these issues sound ongoing, deliver your 4Runner to Toyota and have our department of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing all issue. Getting accessories, notably aftermarket parts and accessories, or using OEM parts initial place might cost a small bit more but could save you money from having to get meager work and damage caused by meager installation work corrected.
  • The battery is low or dead. The battery in your Toyota 4Runner is every critical. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did some decades ago, and they don't certainly require maintenance. The value of a new one depends on the type of Toyota you commute, but check our current service coupons and specials.
  • New Spark Plugs or Plug Wires are needed for your Toyota 4Runner. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or old, you will experience meager performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, major to more expensive repairs.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your Toyota 4Runner’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is commonly caused by neglected maintenance, which is why Coggin Toyota at the Avenues offers a complimentary multi-point inspection with every Toyota service. If you have an issue with your catalytic converter and don't get it serviced, your Toyota 4Runner will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause alternative problems from overheating.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your Toyota 4Runner is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your Toyota 4Runner. Some of these include ignition timing, shifting automatic transmissions controlling engine speed, and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of different things. It can be as simple as your gas cap being loose or as serious as engine knocking. If your check engine light is on in your Toyota 4Runner, contact Coggin Toyota at the Avenues. Our Toyota service department can help you find out what code is turning your check engine light on or inspect why your check engine light is flashing. Contact Coggin Toyota at the Avenues today!

How many miles can you drive with the check engine light?

The safest bet is to decipher the code and then plan your strategy accordingly. If you check engine light is flashing, we recommend that you pull over and contact Coggin Toyota at the Avenues to help select if your vehicle is safe to travel to work in or if we recommend a tow truck. Since all check engine code has its own level of severity, it is difficult to predict how many miles you can travel to work with the warning light on. It could be anything from a bad sensor to plug wires needing to be replaced.

How much does it cost to get the engine light checked?

The middle cost for a check engine light diagnosis & testing is mostly between $88 and $111. The excellent news, Coggin Toyota at the Avenues offers complimentary multi-point inspections and free diagnostics, in most cases, to aid choose the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not appropriately tightened to a more alarming failure identical a bad catalytic converter or a problem with one of the car's oxygen sensors, so it excellent to get the usable code reading and diagnosis.

Toyota 4Runner Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your 4Runner. There are hundreds of different codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling basic diagnostics will give you useful knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, obvious and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of possible OBD codes, there are also hundreds of possible reasons for the light, including:

  • Loose Gas Cap or Missing Gas Cap
  • Old Battery
  • Bad Spark Plugs
  • Fuel and air metering systems problems
  • Emissions controls issues
  • Computer output circuit issues
  • Ignition system faults
  • O2 Sensor
  • Transmission issues
This is why it is important for someone who does not have a lot of automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out rapidly by a certified Toyota mechanic. If the engine light comes on due to a forceful concern, you risk damaging your car added by not repairing the issue correct away. Call Coggin Toyota at the Avenues at 9043376618 today or schedule your check engine light service online today!

Toyota 4Runner Check Engine Light

A flashing light indicates that the problem is noticeable and if not taken care of immediately may result in gargantuan damage to the vehicle. If the check engine light in your Toyota 4Runner starts flashing, that means that the problem needs prompt attention and your Toyota should be brought in immediately. This blinking light usually indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can quickly raise the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can absolutely be the cause. A bad, old or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is flashing, please contact our squad of automotive consultants at Coggin Toyota at the Avenues today by calling 9043376618.

Check Engine Light Service Toyota 4Runner

What do you do when you’re driving along in your Toyota 4Runner and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Toyota owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your Toyota 4Runner checked as soon as possible. Ignoring that warning could end up causing major damage to expensive engine components.

When your Toyota 4Runner's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic scan tool that is used by our Toyota auto repair mechanics at Coggin Toyota at the Avenues. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced professional to determine the issue and repair it.

Toyota 4Runner Check Engine Light Flashing

Although there are countless potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several common causes including something as simple as a loose gas cap. Other common reasons for a Check Engine Light are damaged oxygen sensor, dirty mass airflow sensor, a malfunction with the fuel injection system, faulty emissions control part, faulty head gasket, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Toyota Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Toyota issue was fixed.

Every Toyota 4Runner was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its crucial systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; Coggin Toyota at the Avenues provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Highly Qualified Service professional.

Will the check engine light reset itself?

The check engine light on your Toyota 4Runner will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your Toyota 4Runner light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Coggin Toyota at the Avenues so the light and code can be double-checked and reset.

Is it safe to drive your Toyota 4Runner with the check engine light on?

This question is not exceedingly available because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is naturally indicated by a dependable glow of the check engine light. If you notice a mixture in the performance of the vehicle, it could be an indication of a more scrupulous problem. If the check engine light is flashing, this means that there is a scrupulous issue and it is recommended to service your Toyota 4Runner suddenly. Call the consultants at Coggin Toyota at the Avenues by dialing 9043376618 so you can describe the issues. Or reduce your speed and bring your Toyota to our certified mechanics as soon as attainable.